Re: Re: Hole Position to -A- only

Re: Re: Hole Position to -A- only
Re: Re: Hole Position to -A- only -- Randy Kimball	Post Reply	Top of thread	Forum

Posted by: Antonio Patino

12/18/2002, 17:19:33

Edit

Maybe it is a concentricity, I have worked with several parts that the designer uses a True position as a concentricity requirment. If I remember correctly this is what I have seen:TP/ dia .002 MMC / A MMCWhere A is the center on another hole to which the machined hole has to be aligned. maybe similar to what you have, hope it helps..Regards

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread