electric discharge machine
Post Reply   Forum
Posted by: vicky612 ®

04/15/2007, 00:23:31

Author Profile
eMail author
Edit

hi,
i need to create an artificially defects on outer race of a bearing(model skf 61806).The bearing can not be dismantled.The defects should be in less than 1mm small.the smaller the defects the better.the gap between the race is too small about 1-2mm to use spark erosion method to defect it.therefore i was advised to use electric discharge machine to defect it.is it able to create such a small defect in extremely limited space?also is there any company available in Australia where they can help me with this.as far as i concern,those company in australia only selling the machine and they dont provide the service to defect it.hope someone can help me if they know any company providing the service in Australia or New Zealand.







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
 

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer