set up angle
	Post Reply		Forum

Posted by: vishukvr ® 04/09/2007, 00:04:39 Author Profile eMail author Edit

hi, what is set up angle in press tool components??????????for example a component set up Angleis 7.5deg in X - direction???????????????????????????????????

Replies to this message

Re: set up angle
Re: set up angle -- vishukvr	Post Reply	Top of thread	Forum

Posted by: randykimball ® 04/09/2007, 16:26:15 Author Profile eMail author Edit

Most likely (hard to tell from the small amount of data provided) they are describing a 7.5° break up from the plane of the remainder of the stock while the sheet is laying on x axis (a table top). The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.

Post Reply Tell a Friend (must be logged in) Alert Admin About Post

Where am I? Original Top of thread