process problem Question
Post Reply   Forum
Posted by: cnjbshi ®

03/21/2007, 08:13:59

Author Profile
eMail author
Edit

Now I face one difficult technologies issue for make one part.
The part had large numbers of cavity_holes(1299 x dia0.64mm_deep=3.15mm)! The layout of holes is in one 34.08x34.08mm area. The pitch=0.7mm, When drill these holes,It could engender that extrusion each other.

Could you give some help about how to avoid above issue?

Thank you!








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
View All   | Next |

Replies to this message

Re: process problem
Re: process problem -- cnjbshi Post Reply Top of thread Forum
Posted by: Olly ®
Barney
03/25/2007, 16:43:33

Author Profile
eMail author
Edit

What a kind of material you should drill?







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread | |
Re: Re: process problem
Re: Re: process problem -- Olly Post Reply Top of thread Forum
Posted by: cnjbshi ®

03/25/2007, 20:05:03

Author Profile
eMail author
Edit

The material is plastic(Peek ESD).







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread | |
Re: Re: Re: process problem
Re: Re: Re: process problem -- cnjbshi Post Reply Top of thread Forum
Posted by: santo1964 ®

05/10/2007, 06:08:40

Author Profile
eMail author
Edit

Laser OR water jet cutting is the best solution







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread | |
Re: Re: Re: Re: process problem Agree
Re: Re: Re: Re: process problem -- santo1964 Post Reply Top of thread Forum
Posted by: cnjbshi ®

05/10/2007, 23:03:15

Author Profile
eMail author
Edit

Thank you!







Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer