|
||||||||||||
|
||||||||||||
| Replacing Cr+6 by Cr+3 in electroplating | |||
| Post Reply | Forum | ||
| Posted by: kamranwasti ® 02/25/2007, 23:28:37 Author Profile eMail author Edit |
Hello everyone, I hope you are all fine. Can someone provide me with guidance regarding replacing Cr+6 by Cr+3? What are the mainstream alternatives for this bit? Regards, Kamran Modified by kamranwasti at Sun, Feb 25, 2007, 23:29:55 |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | | |
| Replies to this message |
| Re: Replacing Cr+6 by Cr+3 in electroplating | |||
| Re: Replacing Cr+6 by Cr+3 in electroplating -- kamranwasti | Post Reply | Top of thread | Forum |
| Posted by: kamranwasti ® 02/26/2007, 01:01:56 Author Profile eMail author Edit |
Please note that this electoplating is being done on Aluminum. |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
