A student nedds help about DRILLERS Smile
Post Reply   Forum
Posted by: MikeF ®

12/31/2006, 06:01:47

Author Profile
eMail author
Edit

Hello

Im a student at the Thechnion (Israeli institute of technology.
I am working on a project about driling machines, and need to find information about the driller itself (things like tempreture it gets to, stress it needs to hold, etc.).

If anyone can help me find that sort of information, or refer me to a data base, it would be great.

Thank you very much,
Mike








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
View All   | Next |

Replies to this message

Re: A student nedds help about DRILLERS
Re: A student nedds help about DRILLERS -- MikeF Post Reply Top of thread Forum
Posted by: randykimball ®
Barney
01/02/2007, 21:57:03

Author Profile
eMail author
Edit

To search for that information use the term "drill".

Search and learn about the flutes, the shank, the point, the web, and styles of sharpening the points.. including thinning the web point.

The most stress is very near the center where the drill actually pushes material away with compressive forces.

The farther out on the diameter you get the higher the cutting surface footage and the more heat that must be displaced.

The cutting edges can be positive or negitive. Why negitive? ... so that the drill will not "screw itself" through thin or soft material and hang.

The rpm in which to spin a drill has everything to do with the diameter and the material it is drilling.

The feed rate is determined by the same factors as rpm is but are effected as well by horse power and drill strength.

..now, go learn more.... good luck.





The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.


Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer