Seeking a beam formula
Post Reply   Forum
Posted by: dal_johnson ®
Huckleberry
10/26/2006, 17:48:19

Author Profile
eMail author
Edit

I am seeking the beam formulas for bending and deflection for a design that I am working on.

The beam will be fixed at both ends.

There will be a uniformly distributed load centered between the ends, but the load does not reach ends.

for example a beam spanning 6 feet, and the distributed load only acting for 2 feet centered from the ends (2 feet from either end)

Any help would be greatly appreciated.








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
View All   | Next |

Replies to this message

Re: Seeking a beam formula
Re: Seeking a beam formula -- dal_johnson Post Reply Top of thread Forum
Posted by: Kelly Bramble ®

11/02/2006, 09:25:32

Author Profile
eMail author
Edit

There is a several beam deflection page and calculators located here: /calculators.htm.

The closest for your application are:

/beam_bending/beam_bending4.htm
and
/beam_bending/beam_bending1.htm








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread
Re: Seeking a beam formula
Re: Seeking a beam formula -- dal_johnson Post Reply Top of thread Forum
Posted by: RBPrice ®

11/01/2006, 22:22:46

Author Profile
eMail author
Edit

Apparently my post regarding a solution to your problem offended the moderator.

Email me for a solution to your problem.








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread | |
Re: Seeking a beam formula Agree
Re: Seeking a beam formula -- dal_johnson Post Reply Top of thread Forum
Posted by: Scooter ®

10/27/2006, 09:12:44

Author Profile
eMail author
Edit

I suggest AISC'S book "Steel Construction Manual". This is a very simple formula. The reference book has several illistrations of beam formulas.

Hope this helps,

Thanks,

Scooter








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread | |
Re: Re: Seeking a beam formula
Re: Re: Seeking a beam formula -- Scooter Post Reply Top of thread Forum
Posted by: dal_johnson ®
Huckleberry
10/27/2006, 10:03:01

Author Profile
eMail author
Edit

I've been using the Canadian Handbook of Steel Construction, among other sources. While it has many beam formulas, it does not have one of the situation desired. For beams with both ends fixed it has for point loads and for a distributed load fully between the beam ends. But not for where the distributed load centered and does not reach the ends.

I also do not readily have access to the book you have referred to. If this situation is in there could you please post the formulas for me.








Post Reply
Tell a Friend (must be logged in)
Alert Admin About Post
Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer