Help Me Solve the torque problem Please
Post Reply   Forum
Posted by: robertedelong ®

08/26/2006, 19:48:58

Author Profile eMail author Edit

re: wind generators; the new models I'm looking at are the low rpm (25-100 rpm)
Permanent magnet; direct drive; regarding the generator; What is the torque required to drive these generators? Lets consider two outputs; 350KW and 1 MW; wind sites usually do not reveal torque or horsepower; To simplify what I'm asking for: how much torque (from say an electric motor or a diesel engine)would be needed to drive a 350 KW generator at maximum load. The same for a 1 MW generator. Forget about starting torque, hysteresis,friction or cogging. I'm asking maximum rating needed. Let's ballpark this if that's OK with you.Thanks for any help you can provide







Post Reply | Tell a Friend (must be logged in) | Alert Admin About Post View All   | Next |

Replies to this message


Re: Help Me Solve the torque problem Please
Re: Help Me Solve the torque problem Please -- robertedelong Post Reply Top of thread Forum
Posted by: Zip ®

08/31/2006, 01:31:07

Author Profile eMail author Edit

Most gensets run @ 1800 R.P.M. I calculate 469 H.P. for
350 K.W. With 1368 ft.lbs. Ballpark!
.746 K.W. per H.P.. H.P.x 5252
----------- = lb.ft. Torque
R.P.M.
Cheers
Z





Zip


Post Reply | Tell a Friend (must be logged in) | Alert Admin About Post Where am I? Original Top of thread
Re: Help Me Solve the torque problem Please
Re: Help Me Solve the torque problem Please -- robertedelong Post Reply Top of thread Forum
Posted by: zekeman ®

08/28/2006, 09:52:09

Author Profile eMail author Edit

torque*rpm*2pi/33000=horsepower
.746KW=1Horsepower
You need to know RPM to get the torque.







Post Reply | Tell a Friend (must be logged in) | Alert Admin About Post Where am I? Original Top of thread | |
Re: Help Me Solve the torque problem Please
Re: Help Me Solve the torque problem Please -- robertedelong Post Reply Top of thread Forum
Posted by: randykimball ®
Barney
08/27/2006, 13:15:28

Author Profile eMail author Edit

1 KW = 1.36 metric HP

so...

350 KW = 475.87 mHP
1000 KW (1 MW) = 1,359.62 mHP


of a slight difference
1 KW = 1.34 electric HP
If you stick with the mHP you will build in a fudge factor.

Unfortunately these do not directly convert to torque.





The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.

Modified by randykimball at Sun, Aug 27, 2006, 13:22:02


Post Reply | Tell a Friend (must be logged in) | Alert Admin About Post Where am I? Original Top of thread | |

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer