lathe module need info

lathe module need info
	Post Reply		Forum

Posted by: dwayne ^®

11/22/2005, 12:46:43

Author Profile Mail author Edit

Centers are used to support the work piece while operating the lathe machine Name the three types of lathe centers and sate the purpose of each

Describe and state the purpose of the following:

(i) Three jaw universal chuck

(ii) Four jaw independent chuck

(iii) Turning between centers

Post Reply | Recommend | Alert

View All

| Next |

Replies to this message

Re: lathe module need info Sad

Re: lathe module need info -- dwayne Post Reply Top of thread Forum

Posted by: Jack Anderson ^®

11/28/2005, 17:24:27

Author Profile Mail author Edit

(i) Three jaw universal chuck: Used for basic turning of O.D. and I.D of parts, that isn't going to need any off-center turning. Can be used for through the spindle of bar stock. ***But caution should be used in through the spindle turning, as to the length of material that is hanging out the end of the none chucked end of the lathe that may or may not be supported.*** if there is a length of material of any length hanging out the spindle speed must be of a very slow speed, like below 50 RPM. There has been terrible accidents on bar material hanging out of none chucked ends of lathes, that have resulted in bodily damage too death, too terrible damage too equipment. It’s call material bar whip.
I am not finished with answers.

Modified by Jack Anderson at Mon, Nov 28, 2005, 17:55:59

Post Reply | Recommend | Alert Where am I? Original Top of thread

Re: lathe module need info

Re: lathe module need info -- dwayne Post Reply Top of thread Forum

Posted by: devitg ^®
Bart
11/27/2005, 18:15:47

Author Profile Mail author Edit

no home work to be do by us , grab the books, they dont bit

Post Reply | Recommend | Alert Where am I? Original Top of thread | |

Re: lathe module need info
Re: lathe module need info -- dwayne	Post Reply	Top of thread	Forum