|
|
|
| Mechanical Design, Manufacturing and Engineering Forum |
|
DFM DFA Training and Trainers
| Engineering
and Design Data | Product
Services Directory | Advertise Engineering Forum | Engineering Specifications Forum | Engineering and Drafting Store | ASME Y14.5M - 1994 GD&T Training |
| POSTING POLICY / RULES | Archive#1 | Archive #2 | Archive #3 | Calculators |
|
|
| Forum Moderators: Administrator |
|
|
| design of profile corrected gear. |  | ||
| Post Reply | Forum | ||
|
Posted by: nandakumar1975 ® 09/27/2005, 00:44:19 Author Profile Mail author Edit |
hello,
i am a mechanical engineer doing design of special equipments. my problem : i need to design a gear for a profile corrected pinion. i have the pinion details. i dont know how to do this. kindly help me. |
| Post Reply | Recommend | Alert | View All | | Next | |
| Replies to this message |
| Re: design of profile corrected gear. | |||
| Re: design of profile corrected gear. -- nandakumar1975 | Post Reply | Top of thread | Forum |
|
Posted by: lbmakem ® 09/27/2005, 15:50:21 Author Profile Mail author Edit |
hi
a little bit of info about the pinion, centre distance & ratio would help. |
| Post Reply | Recommend | Alert | Where am I? Original Top of thread | | | |
| Re: Re: design of profile corrected gear. |  | ||
| Re: Re: design of profile corrected gear. -- lbmakem | Post Reply | Top of thread | Forum |
|
Posted by: nandakumar1975 ® 09/28/2005, 23:53:17 Author Profile Mail author Edit |
hai 'les@jpullan4.freeserve.co.uk'
a mail has been sent to the above address. kindly have a look at it. |
| Post Reply | Recommend | Alert | Where am I? Original Top of thread |
| Re: Re: design of profile corrected gear. | | ||
| Re: Re: design of profile corrected gear. -- lbmakem | Post Reply | Top of thread | Forum |
|
Posted by: nandakumar1975 ® 09/27/2005, 22:55:15 Author Profile Mail author Edit |
thanks for attention. pinion details are: no of teeth = 11 module = 3 pressure angle = 14.5deg pitch dia = 33mm OUTTER DIAMETER = 40.40 ROOT DIAMETER = 27.4 SPAN OVER TWO TEETH = 14.21/14.28 CORRECTION AMOUNT = 0.70 TYPE OF TEETH = FELLOWS STUB TEETH ECCENTRICITY T.I.R = 0.10 OD ECCENTRICITY T.I.R = 0.10 TOOTH PROFILE ERROR = 0.071 (JIS B1702 GRADE 8) test gear and pinion mating details are : the ratio should be 6 adj center distance hope these are enough. in case u require more information, kindly contact me. |
| Post Reply | Recommend | Alert | Where am I? Original Top of thread | | | |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
