|
||||||||||||
|
||||||||||||
| Using Precision Balls to Seal Passageway | |||
| Post Reply | Forum | ||
|
Posted by: Just Another Mech. Engineer ® 09/14/2005, 16:06:28 Author Profile Mail author Edit |
I plan to press fit ball bearings into drilled passageways in a pneumatic manifold to seal them. Specifically I’ll be using 7/64, 5/32 and 1/4 ball bearings in a Type 2024 Aluminum manifold. Does anyone have any suggestions as to what material and grade of bearing I should use and how much press fit? Thank you. |
| Post Reply | Recommend | Alert | View All | | Next | |
| Replies to this message |
| Re: Using Precision Balls to Seal Passageway | |||
| Re: Using Precision Balls to Seal Passageway -- Just Another Mech. Engineer | Post Reply | Top of thread | Forum |
|
Posted by: tooleng ® 11/08/2005, 14:47:04 Author Profile Mail author Edit |
.15mm press and stake.Any bearing grade precision ball. |
| Post Reply | Recommend | Alert | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
