Plastic Injection

Plastic Injection
	Post Reply		Forum

Posted by: bryantys ^®

03/05/2005, 05:50:00

Author Profile Mail author Edit

Hi,
I was having some technical problem on plastic injecting molding. My question is;

For slide with slanted surface of plastic injectin molding, how to prevent the plastic parts break during ejection of the part from the mold? Is there any way to prevent this event by using stronger raw material like glass filled? Will the stronger structure ( increase the area or volume of injected plastic ) prevent the plastic break during ejection?

Hope that someone can help me by answering my question above.

Thanks

Post Reply | Recommend | Alert

View All

| |

Replies to this message

Re: Plastic Injection

Re: Plastic Injection -- bryantys Post Reply Top of thread Forum

Posted by: randykimball ^®
Barney
03/05/2005, 14:21:28

Author Profile Mail author Edit

I'm not sure I understand the question.
You may try rewording it.
However, it sounds like you are asking someone to give you trade knowledge with which they make their living.
Perhaps someone will share that knowledge.
People are careful with trade skills that feed their families. You may have better luck, ... if ... they could mail you direct and not broadcast it to the world. ..and .. if they can be convinced you are not in competition with them.
I, myself, am not skilled in that trade.
Good luck,
-randy-

The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.

Post Reply | Recommend | Alert Where am I? Original Top of thread

Re: Plastic Injection
Re: Plastic Injection -- bryantys	Post Reply	Top of thread	Forum