Mechanical Design, Manufacturing and Engineering Forum
[ Home ] [ Search ]  [ Design Resources ] [ Product and Services Directory ]
[ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators]
Forum Moderators: randykimball, Administrator

gear puller? Sad
Post Reply   Forum
Posted by: dwaldron ®

12/16/2004, 00:03:10

Author Profile Mail author Edit

I have a 1.5 inch shaft with two sealed bearings about 6 inches apart on the shaft, and a 6 inch wheel hub, all factory installed. The hub has never been removed, now over 25 years old. A 6 inch gear puller won't move the bearings along the shaft. Any ideas on how to get this bad bear off?

I was thinking I may be able to breach the bearing seal, then squirt WD-40 inside the hub colar that houses the two bearings. I plan to replace the bearing anyway. Is this my solution? 







Post Reply | Recommend | Alert Rate View All   | |

Replies to this message


Re: gear puller?
Re: gear puller? -- dwaldron Post Reply Top of thread Forum
Posted by: maytag ®

12/16/2004, 03:14:13

Author Profile Mail author Edit
I'd break out the oxy/acet torch and a small cutting tip.  You can probably  nip enough of the races out to have enough room to remove the balls or rollers 1 at a.time-after several come out the hub should come off leaving only the inner races on the shaft which if you are proficient enough you can cut off with the torch.  Maytag






Post Reply | Recommend | Alert Rate Where am I? Original Top of thread | |
Re: gear puller? Agree
Re: Re: gear puller? -- maytag Post Reply Top of thread Forum
Posted by: dwaldron ®

12/16/2004, 13:14:28

Author Profile Mail author Edit
Thanks. I figured it was time for "seize and destroy!"






Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer