Design and Engineering Forum
[Home] [Design Resources]
[ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators]

casting and forging Smile
Post Reply   Forum
Posted by: nunang ®

09/01/2004, 04:59:18

Author Profile Mail author Edit

Please some body inform us on brief  specification or requirement on

"pump impeller casting" and " steam turbine disk forging".

Thanks in advance







Post Reply | Recommend | Alert Rate View All   | Next |

Replies to this message


impeller and turbine disk forgings
Re: casting and forging -- nunang Post Reply Top of thread Forum
Posted by: randykimball ®
Barney
09/01/2004, 19:59:23

Author Profile Mail author Edit
You are asking to have an intire science expressed in a brief statement. It is with considerable knowledge and experience that such products are forged. In fact this is where some of the latest state of the art technological improvements are currently being made in forging and machining processes. Many top shelf impellers are now being CNC machined from single billets, this was not possible until the latest CNC machining centers were developed.

I wish I had a better answer, but it just takes acquired skills and knowledge. .. and depends greatly on the application. For example the speed that the impeller rotates, the product to be pumped, the temp. it operates in, the size, and so on.

You may be able to find some material information on pump making company web sites. I would think they may furnish specs. on materials for some pumps based on the need to know if they are compatible with different products to be pumped. However, I feel sure you would have a hard time getting them to reveal their closely guarded methods of forging and casting impellers billets.

-randy-




The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.

Modified by randykimball at Wed, Sep 01, 2004, 20:06:16

Post Reply | Recommend | Alert Rate Where am I? Original Top of thread | |
Re: impeller and turbine disk forgings Smile
Re: impeller and turbine disk forgings -- randykimball Post Reply Top of thread Forum
Posted by: nunang ®

09/01/2004, 22:00:37

Author Profile Mail author Edit

Randy, thanks a lot,  you are right; my question was too open.

by the way we hope you or some one else have some information on these, I am beginer on this area and intent to develope my self, I have already some data from standards/text books/result of material analysis of existing; here is  more specific data of parts

  • Impeller enclosed type, dia 325 mm, material 410, fluid water at 100 C, 3000 rpm, 200 atm disch., horiz pump.
  • Steam turbine disk, curtis stage, material 4340, dia 800 mm, thk 25 mm,  4900 rpm

what we need is about : requirements of material mech. and physical properties, test during/after working process.

regards







Post Reply | Recommend | Alert Rate Where am I? Original Top of thread | |
impeller and turbine disk forgings
Re: Re: impeller and turbine disk forgings -- nunang Post Reply Top of thread Forum
Posted by: randykimball ®
Barney
09/03/2004, 00:18:22

Author Profile Mail author Edit
Now, there is the needed data, good job.
However you have left my experience area, perhaps someone will pick up the question and provide some additional guidance.

-randy-




The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.


Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer