Posted by: Administrator ® 02/26/2004, 08:48:03 Author Profile Mail author Edit

Hello all, If you have a couple of minutes, please review the following resource page and reply to this thread with your comments and suggestions. /calculators/mass_estimate_worksheet.htm Thank you!

Replies to this message

Re: I Need Feedback - Assembly Mass Estimation Worksheet
Re: I Need Feedback - Assembly Mass Estimation Worksheet -- Administrator	Post Reply	Top of thread	Forum

Posted by: Cragyon ® 03/01/2004, 09:33:05 Author Profile Mail author Edit

Well, I like it, however, you might set it up so that it prints onto a standard sheet and is readable. When I print it, it comes out on three standard sheets of paper all broke up.  You might turn the display 90 degrees. Also, when I leave the sheet it does not remember my original inputs.

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread

Re: Feedback
Re: I Need Feedback - Assembly Mass Estimation Worksheet -- Administrator	Post Reply	Top of thread	Forum

Posted by: RandyKimball ® 02/26/2004, 20:03:22 Author Profile Mail author Edit

Hi, I like it. Do these paste and run in MS Excel? I could just find out but thought the question would be a natural question from the user group. -randy- The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread

| |

Re: Feedback
Re: Re: Feedback -- RandyKimball	Post Reply	Top of thread	Forum

Posted by: Administrator ® 02/29/2004, 20:06:45 Author Profile Mail author Edit

Currently,  the data does not.  I believe this tool needs some work so that users can import from the tool.  For this tool to be practical as is on EE, I believe the user should be able to store the data and come back and edit at a later time.

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread