|
|
|
| Design and Engineering Forum |
| [Home] [Design Resources] [Technology Store] |
| [Archive#1] [Archive #2] [Archive #3] [Calculators] |
|
|
| Wear & friction test - Pin on disc |  | ||
| Post Reply | Forum | ||
|
Posted by: antony ® 01/31/2004, 01:24:09 Author Profile Mail author Edit |
We are having a Pin on disk Instrument for the measurement of wear & friction co-efficient. In one of our testing, we obtained the following results . Co-efficient of friction for steel disc (Hard chrome plated with 1000Hv hardness) with steel pin (58 HRc)is 0.64 From the literature available tell us that the co-efficient of friction for Steel pin on steel disc is 0.4. Can anybody explain, why the co-efficient of friction for steel pin on hard chrome plated steel disc is on the higher side? kindly explain... Modified by antony at Mon, Feb 02, 2004, 22:25:01 |
| Post Reply | Recommend | Alert | Rate | View All | | Next | |
| Replies to this message |
| Re: Wear & friction test | |||
| Re: Wear & friction test - Pin on disc -- antony | Post Reply | Top of thread | Forum |
Posted by: RandyKimball ®  01/31/2004, 18:55:55 Author Profile Mail author Edit |
Was there a variation in surface roughness??
.. I suspect so .. ...else.. hopefully someone is more experienced in this matter than I, and would be kind enough to reply. -randy- The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them. Modified by RandyKimball at Sun, Feb 01, 2004, 10:15:56 |
| Post Reply | Recommend | Alert | Rate | Where am I? Original Top of thread |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer