Re: Re: Is this GD&T callout illegal?

Re: Re: Is this GD&T callout illegal?
Re: Re: Is this GD&T callout illegal? -- Cragyon	Post Reply	Top of thread	Forum

Posted by: Doug Bailey

04/14/2003, 13:29:32

Edit

So, the 0.5 tolerance zone would JUST be relevant between the 3 holes in the pattern? An engineer once told me that if the callout looks like this, it means perpendicularity is controlled. I told him that I didnt think so and that there would have been a perpendicularity callout IF it was implied. Its an ongoing argument.Thank you for the input.

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread