Replies to this message

Re: SYMMETRICAL AXIS OF A HOLE USED AS REFERENCE
Re: SYMMETRICAL AXIS OF A HOLE USED AS REFERENCE -- Esteban Celemin	Post Reply	Top of thread	Forum

Posted by: Cragyon 02/20/2003, 07:17:00 Edit

Defining a surface to be perpendicular to a axis (hole, pin, etc..) is done by establishing the the axis feature as a datum, then specifying the surface as perpendicular to the axis datum. I don't know what a "symmetrical axis of a hole" is... Can you elaborate? : Hello, : I am facing a problem when l need to establish the perpendicularity tolerance of a surface related to an axis. : This is my doubt: : Is it possible to use the symmetrical axis of a hole as reference axis to relate the perpendicularity tolerance to this axis? : This would mean that the perpendicularity tolerance of the surface would be related to the symmetrical axis of the hole. : Thanks a lot, : Esteban

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread