Membership Services

Re: Spur Gear Design

[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by M.Hassan (194.225.40.7) on December 21, 2002 at 05:33:31:

In Reply to: Spur Gear Design posted by sarang on July 23, 2002 at 02:28:06:

: Can any body help me for following :
: I am designing the Spur gear with Pinion having 8 number of teeths & Gear 34 number of teeth.
: Dimetral Pitch: 48
: Pressure angle: 20 degrees

: 1. How much should be the Profile shift correction factor for Pinion(8 no. of teeths) ?
: 2. What will be parameter values after applying correction fator ?

: Please provide details of this design.
: Thanks in adv.

: Sarang

Follow Ups:

Post a Followup

Subject: Re: Re: Spur Gear Design

Comments:
: : Can any body help me for following : : : I am designing the Spur gear with Pinion having 8 number of teeths & Gear 34 number of teeth. : : Dimetral Pitch: 48 : : Pressure angle: 20 degrees : : 1. How much should be the Profile shift correction factor for Pinion(8 no. of teeths) ? : : 2. What will be parameter values after applying correction fator ? : : Please provide details of this design. : : Thanks in adv. : : Sarang

[ Home ][ Forum Archive ] [ Active Engineering Forum ]