Re: ASME Section VIII Appendix Y (flange) calcs


[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Juárez Pérez Luis (148.204.208.246) on December 17, 2002 at 16:59:54:

In Reply to: ASME Section VIII Appendix Y (flange) calcs posted by Allen Forsman on August 19, 2002 at 07:41:43:

: I am attempting to perform Appendix Y stress calculations on a custom flange design for a test article. Two of the stress formulas, Eq's. 15a (tangential flange stress at ID) and 16a (longitudinal hub stress) refer to a variable (theta sub B = slope of flange face at inside diameter, rad). No other references to this variable or how it is obtained can be found in Appendix Y or in Appendix 2. Any idea where this comes from? Any help would be greatly appreciated.




Follow Ups:



Post a Followup

Subject: Re: Re: ASME Section VIII Appendix Y (flange) calcs

Comments:


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer