Membership Services

Burst strenght of 430 Stainless Steel Tube

[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Henry (64.80.27.245) on December 04, 2002 at 14:35:28:

I'm hoping someone can help me. I have a stamped stainless steel part, a flanged tube. The material is 430 stainless, which has been stamped, annealed and then stamped again at least 3 times into the final shape. The approx dimensions of the part are 1.25" lenght, 1.5" inner diameter and a .050" wall thickness. Can anyone tell me how I calculate a burst pressure for this part? I have a requirement to perform a 400 psi leak test, but want to be sure the material hold up before attempting this.

Thanks in advance for your help
Henry

Follow Ups:

Re: Burst strenght of 430 Stainless Steel Tube John Andrews 12:52:08 12/10/02 (0)

Post a Followup

Subject: Re: Burst strenght of 430 Stainless Steel Tube

Comments:
: I'm hoping someone can help me. I have a stamped stainless steel part, a flanged tube. The material is 430 stainless, which has been stamped, annealed and then stamped again at least 3 times into the final shape. The approx dimensions of the part are 1.25" lenght, 1.5" inner diameter and a .050" wall thickness. Can anyone tell me how I calculate a burst pressure for this part? I have a requirement to perform a 400 psi leak test, but want to be sure the material hold up before attempting this. : Thanks in advance for your help : Henry

[ Home ][ Forum Archive ] [ Active Engineering Forum ]