Speed Reducer Help Welcome!


[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Pedro Lobo (213.30.42.222) on November 26, 2002 at 15:37:27:

I´m a mechanical eng student and I´m doing a project of a speed reducer with the following data:
-input power 5.5 kw at 1500 rpm
-two horizontal output shafts aligned with 200 rpm and 300 rpms conter rotating
-horizontal input
I´ve calculated all the ratios but i´m having problems with the number of teeth required for each set of gears.
The ratios are the following:
from input to the 300 rpm output
1/1.8 cone gears
1/1.63 cylindrical gears
1/1.63 cylindrical gears
from input to 200 rpm output
1/1.8 cone gears
1/4
Any coments will be welcome.
Best regards
Pedro Lobo


Follow Ups:



Post a Followup

Subject: Re: Speed Reducer Help Welcome!

Comments:


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer