Membership Services

Tapered Motor Shaft and mating Boss Design

[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Elie (137.230.1.12) on November 25, 2002 at 12:04:53:

Hi All,

I was wondering if any of you could help me out....
I am desinging a product that uses a Hydraulic Motor that has a 30mm Dia..1:10 Tapered Shaft.

I am designing a Boss that sits on the shaft and it tightened down with a castle nut and retained using a split pin.

Can anyone point me in the direction of a standard for designing this interface.

Regards

elie

Follow Ups:

Post a Followup

Subject: Re: Tapered Motor Shaft and mating Boss Design

Comments:
: Hi All, : I was wondering if any of you could help me out.... : I am desinging a product that uses a Hydraulic Motor that has a 30mm Dia..1:10 Tapered Shaft. : I am designing a Boss that sits on the shaft and it tightened down with a castle nut and retained using a split pin. : Can anyone point me in the direction of a standard for designing this interface. : Regards : elie

[ Home ][ Forum Archive ] [ Active Engineering Forum ]