Membership Services

Re: Re: Metric Shaft and Hole Tolerance

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Randy on March 02, 2002 at 19:06:30:

In Reply to: Re: Metric Shaft and Hole Tolerance posted byDustin on February 08, 2002 at 11:16:42:

: : I need some advice on finding ISO tolerance for shafts and holes (h7, h6, ... etc). I know that there has to be a simple place to find this but all I can find are the sights that want $60 for the official spec.
: : Thank You,

: This page on Engineers Edge might help

: /iso_tolerance.htm

If I was going to spend $60, I'd add a little get a copy of "Machinery's Handbook". The 'H' fits you ask about are in there along with thousands of other things you wish you knew where to find.

It is printed out of Industrial Press Inc. of NY and is the bible in such matters. Most shop tool supply houses carry it.

.. good hunting!

Follow Ups

Subject: Re: Re: Re: Metric Shaft and Hole Tolerance

Comments:: : : I need some advice on finding ISO tolerance for shafts and holes (h7, h6, ... etc). I know that there has to be a simple place to find this but all I can find are the sights that want $60 for the official spec. : : : Thank You, : : This page on Engineers Edge might help : : /iso_tolerance.htm : If I was going to spend $60, I'd add a little get a copy of "Machinery's Handbook". The 'H' fits you ask about are in there along with thousands of other things you wish you knew where to find. : It is printed out of Industrial Press Inc. of NY and is the bible in such matters. Most shop tool supply houses carry it. : .. good hunting!

[ Home ][ Forum Archive ] [ Active Engineering Forum ]