Re: Re: How to Design a Gearbox?


[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by iman (217.219.18.10) on January 22, 2003 at 02:23:57:

In Reply to: Re: How to Design a Gearbox? posted by Gouresh on October 17, 2002 at 06:46:31:

: Hi,

: Before you start designing a gear box, you should know the input and output requirements, such as,
: - application, ex: machine tools
: - input and No. of output shafts speeds, power and positions (speed ratio)
: - power to be transmitted
: - allowable space, etc.
: Then you have to decide,
: - type of gear pairs to be used
: - No. of step-downs, or step-ups
: - No. of levels of gears (widthwise)
: - bearing sizes
: - kinametics (gear train)
: - lubrication provision
: - accuracy required
: - development of kinametics (gear train) showing cross-section views
: - check for strengths, life etc
: - check for assy./dis-assy. easiness etc.

: You will have to consider everything depending on the application. It is difficult to list down the steps to be followed.




Follow Ups:



Post a Followup

Subject: Re: Re: Re: How to Design a Gearbox?

Comments:


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer