|
GD&T DRIFT | |||
Post Reply |
Mechanical Engineering Forum |
Posted by: belinda63 ® 06/09/2010, 14:58:25 Author Profile eMail author Edit |
does the GD&T Straightness also cover drift if the diameter symbol is used? Can't seem to find a clear answer to this in the GD&T book. I don't care about the shape of the hole but don't want it to walk more than .002 per inch. Sure would appreciate your help on this. Belinda Manning
|
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | Previous | Next | |
|
||||
Replies to this message |
: GD&T DRIFT | |||
: GD&T DRIFT -- belinda63 |
Post Reply |
Top of thread |
Mechanical Engineering Forum |
Posted by: Kelly Bramble ® 06/09/2010, 15:13:11 Author Profile eMail author Edit |
Yes Ma'am, the diameter symbol is optional for a straightness specification on a diameter.
|
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | Previous | | |
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer