Results 1 to 4 of 4

Thread: Tolerances of Thread Feature

  1. #1
    Senior Engineer
    Join Date
    Apr 2011
    Location
    Monclova, Coahuila, Mexico
    Posts
    39

    Tolerances of Thread Feature

    anyone can help about to the Norm used so know what it is the permissible tolerance in a thread of tapped hole speaking of the major diameter at minor diameter

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    By defualt tolerances of location, orientation or datum reference apply to the axis of the thread as derived from the pitch diameter..

    Anyway, the same location or orientation tolerance can be applied to the minor or major diamater.

    See: http://www.engineersedge.com/tolerance_chart.htm

  3. #3
    Senior Engineer
    Join Date
    Apr 2011
    Location
    Monclova, Coahuila, Mexico
    Posts
    39
    so can understand me becuase I don't undestand whatever you say, Imagine I have a drawing to drill a plate 4" with tapped holes and this plate calls me 1"Ø with a tolerance +-0.005 mills, I know that is very very hard get it that tolerance so I would like to know if with the norm that you say I can determine how much can get.

    regards,

  4. #4
    Technical Fellow jboggs's Avatar
    Join Date
    Mar 2011
    Location
    Myrtle Beach, SC
    Posts
    908
    The answer to your question depends on two things: who will make the part, and what you are willing to pay. The tolerances you are asking for are not highly unusual, but a typical machine shop might not be able to do it. Any answer you get here will not mean much to the guy that actually has to make the part. You should look at the capabilities of the shop.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •