Image attachment failed - reattach
In Detail A view, Im installing a hyd. motor in a welded plate and the install guide calls for flatness but what does "S" mean in regards to the tolerance.
Same for the surface finish. Im not sure what "V" means for the average roughness.
Last edited by Kelly_Bramble; 03-20-2023 at 12:07 PM.
My guess... is that somewhere on the engineering drawing there is a note, table or reference document that defines "S" as well as V, U and M.
Tell me and I forget. Teach me and I remember. Involve me and I learn.
Thanks, I did find it in a separate guide.