Results 1 to 6 of 6

Thread: Pizza Oven base

  1. #1
    Associate Engineer
    Join Date
    Nov 2017
    Posts
    2

    Pizza Oven base

    Hello everyone
    I'm looking for a little advise on fabricating a pizza oven base from mild steel and I
    need to know if the tube size and thickness is going to support the weight.
    I was thinking of using 50mm x 50mm x 6mm thickness square mild steel hollow section and the weight of the oven
    will be around 1200kgs. Standard square top with 3 supporting bars and 4 braced legs.
    Any advice would be greatly appreciated.....

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    A36, carbon steel. Keep it simple.
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

  3. #3
    Associate Engineer
    Join Date
    Nov 2017
    Posts
    2
    see basic design
    Attached Images Attached Images

  4. #4
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Looks good to me... Welding?
    Tell me and I forget. Teach me and I remember. Involve me and I learn.

  5. #5
    Principle Engineer
    Join Date
    May 2015
    Posts
    216
    If you do not have a fabrication shop handy, you can buy custom tables.

    Take a look at American Grinding:

    http://www.americangrinding.com/brut...s-gallery.html

  6. #6
    Banned
    Join Date
    Nov 2017
    Posts
    2
    Sounds good. Mild steel should be enough in my opinion or would you be open to other options?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •