Results 1 to 3 of 3

Thread: Profile tolerance inquire

  1. 03-15-2016, 01:03 AM #1
    bt.darshan
    bt.darshan is offline
    Associate Engineer
    Join Date
    Jan 2013
    Posts
    7

    Profile tolerance inquire

    Please help me on the inquires shown in attached image related to profile tolerance callout.
    Standard: ASME Y14.5
    Any help is greatly appreciated!

    Thank you in advance.

    Warm Regards,
    Darshan
    Attached Images Attached Images
    Last edited by Kelly_Bramble; 03-15-2016 at 04:04 PM. Reason: spelling
    Reply With Quote Reply With Quote
  2. 03-15-2016, 09:05 AM #2
    Kelly_Bramble
    Kelly_Bramble is offline
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Yes, "4 PLACES" the start and end point is obvious and correct to control the 4 radius's.
    Tell me and I forget. Teach me and I remember. Involve me and I learn.
    Reply With Quote Reply With Quote
  3. 03-15-2016, 10:40 PM #3
    bt.darshan
    bt.darshan is offline
    Associate Engineer
    Join Date
    Jan 2013
    Posts
    7
    Thks Kelly
    Reply With Quote Reply With Quote
« Degrees included in feature control frame for flatness | Source for Tolerances and Shaft (Mis) Alignment »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules