Results 1 to 3 of 3

Thread: Japanese GD&T standard?

  1. #1
    Uday D
    Guest

    Japanese GD&T standard?

    I have Japanese drawings and when i see it i did not understood it. Center of hole is shown as A1, B1 and C1 as if it is datum point. Similar Datum target point symbol can be seen on other places as well like C2, B2, A3 and so on. My ASME logic is also not helping me to understand it. Do Japanese follow some kind of GD&T standard which i am not aware of?

  2. #2
    Principle Engineer Cragyon's Avatar
    Join Date
    Feb 2013
    Location
    Newark, NJ
    Posts
    299
    What standard is stated on the engineering drawing?

  3. #3
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Without seeing the drawing or specification I can't be 100% sure, however the Japanese do use a derivative of ISO 1101 G&T standard.

    My guess is that this is an implied datum origin or an extension of datum target location definitions.

    Can you post the relevant details of the drawing?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •