Results 1 to 6 of 6

Thread: Direction to tap thread?

  1. #1
    Associate Engineer
    Join Date
    Sep 2011
    Posts
    2

    Direction to tap thread?

    I feel a bit of a muppet for asking this, but I'm creating a drawing which has a tapped hole all the way through, and I can't find any information on how to actually indicate within the ISO guidelines on which side to tap the hole from.

    Any ideas, or resources that you could point me to would be gratefully accepted.

    Thanks.

  2. #2
    Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Doesn't matter where they tap from as your asking for threads "all the way through".

    Don't forget that there should be thread relief on both sides of the threaded hole feature. If you have specific requirements as such - state it...

    BTW, welcome to EE!

  3. #3
    Associate Engineer
    Join Date
    Sep 2011
    Posts
    2
    This explains why I felt like a muppet ;]

    I'm not a machinist, but I have tapped my share of holes but for some reason I'd never thought about the thread being operable from either side

    Thankyou for the knock on the head and the welcome :]

  4. #4
    Technical Fellow
    Join Date
    Feb 2011
    Posts
    1,043
    Quote Originally Posted by logos View Post
    I'd never thought about the thread being operable from either side
    Welcome, and the unofficial rule-of-thumb is to drill and tap from the side that the Leader points to on the drawing.

    I was a Toolmaker in a muuuuuuch earlier time-frame.

  5. #5
    Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    Bet ya I can produce a drawing where you can't drill and tap from from the leader side.

    Nyuk, Nyuk, Nyuk Wowowowow ..

    Quote Originally Posted by PinkertonD View Post
    Welcome, and the unofficial rule-of-thumb is to drill and tap from the side that the Leader points to on the drawing.

    I was a Toolmaker in a muuuuuuch earlier time-frame.

  6. #6
    Technical Fellow
    Join Date
    Feb 2011
    Posts
    1,043
    Quote Originally Posted by Kelly Bramble View Post
    Bet ya I can produce a drawing where you can't drill and tap from from the leader side.
    I bet you can Kelly, what's worse I bet you would! LOL

    I was a Draftsman in a not quite so muuuuuuch earlier time-frame.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •