Results 1 to 3 of 3

Thread: True Position of a diameter back to 2 datums.

  1. #1
    Associate Engineer
    Join Date
    Nov 2013
    Posts
    4

    True Position of a diameter back to 2 datums.

    How can I calculate the true position of a hole back to 2 datums (diameters). The feature control frame states that the true position of the hole should be within a diametrical tolerance of .5 MMC to datum "A" at MMC and datum "B" at MMC. I understand the calculation when going back to a single datum.

  2. #2
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625
    The tolerance zone is oriented and located to the specified datums'. So, depending on the relationship between the datums and the hole one will either measure a location (distance) or an orientation.

    Can you be more specific on what the relationships are between the hole and the datums'?

  3. #3
    Technical Fellow Kelly_Bramble's Avatar
    Join Date
    Feb 2011
    Location
    Bold Springs, GA
    Posts
    2,625

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •