Results 1 to 3 of 3

Thread: Hello, Just Joined

  1. 09-10-2013, 07:46 PM #1
    kendor
    Guest

    Hello, Just Joined

    My name is kendor. I just found this site and just joined. I couldn't find an introduction thread so I came here, where I'm most comfortable. I'm a GD&T fanatic so let's roll.
    Reply With Quote Reply With Quote
  2. 01-12-2014, 01:26 AM #2
    sparkfinders
    Guest

    I'm new too!

    Quote Originally Posted by kendor View Post
    My name is kendor. I just found this site and just joined. I couldn't find an introduction thread so I came here, where I'm most comfortable. I'm a GD&T fanatic so let's roll.
    Hi everyone,

    I'm new too, need some guidance here... please.
    Reply With Quote Reply With Quote
  3. 01-13-2014, 05:12 PM #3
    Belanger
    Belanger is offline
    Project Engineer
    Join Date
    May 2011
    Location
    Michigan
    Posts
    78
    What would you like to discuss? If you're new to GD&T, one thing is to learn the names of the 14 symbols, and also what category they are lumped into.
    Reply With Quote Reply With Quote
« torque vs thread engagement | Flatness with Datum Alternative »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules