|
|||||||||
|
|||||||||
| MS3106F14S-2P |  | ||
Post Reply |
Computer Aided Design CAD Forum |
||
| Posted by: MTRITON ® 08/17/2010, 09:50:50 Author Profile eMail author Edit |
Would anyone just happen to have a 3D model of connector MS3106F14S-2P (either Amphenol or ITT Canon)? A stp file is preferred over iges! Thanks. |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | |
| Replies to this message |
| : MS3106F14S-2P | | ||
: MS3106F14S-2P -- MTRITON |
Post Reply |
Top of thread |
Computer Aided Design CAD Forum |
| Posted by: jbeckproe ® 08/17/2010, 10:25:27 Author Profile eMail author Edit |
check out Engineers Edge search for more information
|
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | |
| : : MS3106F14S-2P | | ||
: : MS3106F14S-2P -- jbeckproe |
Post Reply |
Top of thread |
Computer Aided Design CAD Forum |
| Posted by: MTRITON ® 08/18/2010, 13:49:44 Author Profile eMail author Edit |
Yep - been there - lots of data sheets - no models for this connector. Also tried 3dcontentcentral. Any other suggestions? |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | |
| : : : MS3106F14S-2P |  | | |
: : : MS3106F14S-2P -- MTRITON |
Post Reply |
Top of thread |
Computer Aided Design CAD Forum |
| Posted by: Kelly Bramble ® 08/18/2010, 14:13:20 Author Profile eMail author Edit |
What CAD system do you have? I can probably can model it from scratch in ten minutes... Modified by Kelly Bramble at Wed, Aug 18, 2010, 14:26:53 |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | |
| : : : : MS3106F14S-2P | | ||
: : : : MS3106F14S-2P -- Kelly Bramble |
Post Reply |
Top of thread |
Computer Aided Design CAD Forum |
| Posted by: MTRITON ® 08/20/2010, 10:52:46 Author Profile eMail author Edit |
We're on Pro/E Wildfire 3.0, M220. I don't know about the 10 minutes - It's a Military connector with attached backshell. Thank you for the offer!! Need 3D solid (stp preferred if done outside of Pro/E). |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | |
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
