|
||||||||||||
|
||||||||||||
| cad pricing |  | ||
| Post Reply | Forum | ||
| Posted by: charles lowery ® 12/13/2009, 17:54:52 Author Profile eMail author Edit |
we need a component making for an old swift lathe,made 1960 ish instead of jotting deign down on a piece of paper, what is the going rate for a 2D drawing say per hour.
any advice would be heilpfull |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All |
| Replies to this message |
| Re: cad pricing | | ||
| Re: cad pricing -- charles lowery | Post Reply | Top of thread | Forum |
| Posted by: Maxisimo ® 12/24/2009, 12:46:36 Author Profile eMail author Edit |
You need an existing part of the lathe drawn in 2d? You could take the part and have it scanned a number of ways, then have the dimensions turned into a 2d drawing. The "going rate" depends on the method you choose and the complexity of the part. |
| Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | |
Powered by Engineers Edge
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer
