### Stress and Compression Analysis Combined Loading Circular Shaft in Direct Compression and Torsion

**Beam Deflection, Stress Formula and Calculators**

Beam Stress and Deflection Calculations for Non-Engineers

Combined Loading on Circular Shaft in Direct Compression and Torsion Equation and Calculator:

Maximum Nominal Tensile or Compressive Stress

Maximum Nominal

Shear Stress

Where:

d = | Diameter | inches | (mm) |

T = | Torque Load | inches | (mm) |

F = |
Applied Load | in-lbs | (mm-N) |

σ' _{a} = |
Stress, Tensile or Compressive | Lbs/in^{2} |
(N/mm^{2)} |

τ'_{a} = |
Stress , Max. Nominal Shear | Lbs/in^{2} |
(N/mm^{2)} |

References:

- Any Machinery's Handbook published since 1931 or,
- Machinery's Handbook, 21st Edition, Page 404 or,
- Machinery's Handbook, 23st Edition, Page 260 or,
- Machinery's Handbook, 27st Edition, Page 261

- Axial Load Capacities for Single Plates Calculator
- Beam Bending Equations / Calculation Supported on Both Ends Uniform Loading
- Beam Bending Equations / Calculation Supported on Both Ends Single Load at Center
- Beam Bending Equations / Calculation Supported on Both Ends Loaded at any Location
- Beam Bending Equations / Calculation Free and Guided on One End, Rigid one End With Uniform Load
- Beam Bending Equations / Calculation Supported on Both Ends With Overhanging Supports of equal Length and Equal Loads
- Beam Bending Equations / Calculation Supported on Both Ends Loaded Two equal Loads
- Beam Bending Equations / Calculation with Ends Overhanging Supports and a Two Equal Loads applied at Symmetrical Locations
- Beam Bending Equations / Calculation with End Overhanging Supports and a Single Load
- Beam Bending Equations / Calculation Cantilevered Beam with One Load Applied at End