Table of Metric Shaft Tolerances per. ISO 286 Chart Calculator
Mechanical Tolerance Chart Data
The following Engineering calculator will show the plus and minus tolerance for the specific ISO 286 Shaft tolerance data. Enter your desired preferred tolerance grade and the nomial size.
Also see Table of Hole Tolerances per. ISO 286
NOTE: Nominal Diameter 250 mm max.
Related Resources:
- ISO Tolerances For Fasteners
- Formulas for Standard International Tolerance (IT) Grades per.ISO 286-1 1993 and ISO 919-1993
- Table of Hole Bore Tolerances per. ISO 286 Calculator
- General ISO Geometrical Tolerances Per. ISO 2768
- Dowel Pin Installation Tolerances
- Class I Fits & Limits Tolerances
- Class II Fits & Limits Tolerances
- Class III Fits & Limits Tolerances
- Class IV Fits & Limits Tolerances
- Class V Fits & Limits Tolerances
- Shaft to Shaft Axial Alignment Design Tolerances Tables
- Tolerance Calculator Floating Fastener Condition
- Tolerance Calculator Fixed Fastener Condition
Link to this Webpage:
© Copyright 2000 -
2024, by Engineers Edge, LLC
www.engineersedge.com
All rights reserved
Disclaimer |
Feedback
Advertising
| Contact
